![]() ![]() For A/T, from a stop and in overdrive, moderately accelerate to 80 Km/h (50 MPH) and cruise for at least 15 seconds. For M/T, accelerate from 0 to 80 Km/h (o to 50 MPH), continue to step 11. Idle with transmission in drive (neutral for M/T) for 2 minutes.ġ0. From a stop, accelerate to 72 Km/h (45 MPH) at 1/2 to 3/4 throttle. Include five different constant cruise speeds, ranging from 40 to 72 Km/h (25 to 45 MPH) over a 10 minute period.Ĩ. ![]() Cruise at 45 to 65 MPH for 10 minutes (avoid sharp turns and hills) Note, to initiate the monitor: TP MODE should =PT, EVAPDC must be >75%, and FLI must be between 15 and 85%Įxecutes the EVAP Monitor (If IAT is within 40 to 100?F)ħ. (some people say 4 mi) (No cruise control!)Ħ. Is IAT 40 to 100? F? If Not, complete the following steps but, note that step 14 will be required to "bypass " the Evap monitor and clear the P1000.Įngine warm-up and provide IAT input to the PCM.ĥ. Drive at 64 Km/h (40 MPH) until ECT is at least 76.7?C (170? F).īypasses engine soak timer. Start vehicle WITHOUT returning to Key Off.ģ. Begin to monitor the following PIDs: ECT, EVAPDC, FLI (if available) and TP MODE. Select appropriate Vehicle & Engine qualifier. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |